User`s manual

Alcorn McBride Binloop User’s Manual Page 27
Get/Set SMPTE time
Description: This command will get or set the current SMPTE time.
Parameters: hh = hours
mm = minutes
ss = seconds
ff = frames
Get Command: CT
Response: hh:mm:ss.ff
Example: Command: CT
Response: 01:59:59.30
Set Command: hh:mm:ss.ffCT
Response: R
Example: Command: 01:59:59.30CT
Response: R
Get/Set SMPTE Mode
Description: This command will get or set the operating mode of the SMPTE module.
Parameters: x = mode number:
0 = read
1 = generate
2 = generate with V-sync
Get Command: SO
Response: x
Example: Command: SO
Response: 2
Set Command: xSO
Response: R
Example: Command: 2SO
Response: R