User`s manual

Alcorn McBride Binloop User’s Manual Page 116
Audio Troubleshooting Guide
Symptom Cause(s) Solution(s)
1) No Audio Output,
Reproducer status LED is
RED
a) Binloop Muted
b) Reproducer Muted
a) Verify that MUTE Button on
front of Binloop is not enabled.
b) Send Unmute Audio command
to affected reproducer.
c) Power-cycle Binloop
2) No Audio Output,
Reproducer status LED is
not RED.
a) Audio output connector
disconnected from unit or
shorted.
a) Restore audio output
connection to Digital Binloop HD.
3) Audio Output distorted on
single reproducer card.
a) Audio output wired
incorrectly - one end of
balanced output might be
shorted to ground..
b) Faulty reproducer
a) Rewire balanced audio output
connection. Leave (-) output
disconnected for connection to
unbalanced inputs.
4) Audio Output distorted -
multiple outputs.
a) Same as (3) above
b) Interconnect ground
loop.
c) Faulty controller
a) Same as (3) above.
b) Power cycle Binloop.
5) Audio sounds high-
pitched, or low-pitched
compared to how it should
sound.
a) Binloop sample rate
does not match sample rate
of the audio file.
b) Change sample rate of Binloop
or audio track.