Owner’s Guide July 30 2001 Printed in Taiwan www.alcon-stc.com.
TABLE OF CONTENTS FEATURES: ♦ POINT-TO-POINT OR POINT-TO-MOBlLE USE ♦ HIGH PERFORMANCE CT-88 FEATURES .................................................................................................................3 ♦ UNlVERSAL INTERFACE ON THE REMOTE/MOBILE FOR FAX / DATA OR OTHER STANDARD PACKAGE .......................................................................................................
Function Keys : Standard Accessories for CT-88 S.M. Base Unit x1 Remote / Mobile Unit Power Supply 30m Cable Antenna(OA-2538) x1 x1 x1 x1 1/2 λ Car Antenna Magnetic Car Antenna Mount x1 x1 DC Cord 1m / 6.5m AT-80 Telephone User’s Manual x1 x1 x1 Base Unit Remote/Mobile Unit INT. Button Tel. Select Button Mobile No.
FUNCTION KEYS : NOTE : " ANSWERING A CALL If there is blackout when the system had the Scramble Function engaged or disengaged, the system will always return to that setting when the power returns. " The system should be in standby mode to engage or disengage the scramble function. ANSWERING WITH THE CT-88 Remote Unit Make sure the Remote POWER switch is ON. 1. When a call comes in, the Normal Telephone will ring. The TEL indicator will flash. 2.
INTERCOM FUNCTION {BETWEEN REMOTE/ MOBILE UNIT AND BASE UNIT} A : Remote / Mobile CALLING BASE UNIT Remote / Mobile 1. Press INTERCOM. The base will emit two short “beeps”. The Remote/Mobile unit INT indicator will begin to flash. 2. The Remote/Mobile will then emit two short rings and then it will continuously ring. Once the Base unit is in use, the INT indicator will continuously illuminate. 3.
Remote/Mobile Remote/ Mobile unit 3. Hang up the normal telephone to deactivate the INT and then pick up the handset again to get the outside call. 4. You will now be able to answer the call that is on hold. 1. The Remote/ Mobile unit will ring. The INT indicator will flash. This means that the Base unit is calling the Remote / Mobile unit. 2. Once you lift the telephone handset, you can begin you conversation . The INT indicator will continuously illminate. 3.
Setting a Representative number for OA-2538 HI-GAIN ANTENNA INSTALLATION : Remote/ Mobile Unit setting your Remote/ Mobile unit representative number on the Base unit. l Set the POWER switch of Remote / Mobile unit to OFF. Base Unit 1. Press SEL and without releasing turn on the Base Unit. 2. All the LED indicators will be displayed and also Indicator No. 1. 3. Press SEL to change to the Remote Unit No. that you wish to represent either "2", "3" and "4". 4. Press the INT button.
COAXIAL CABLE MOUNING 4. Feed the coaxial cable through the support. Mount the high gain antenna on to the support by aligning the holes found on the antenna support with those found on the antenna. Secure the structure by using the screws provided (see illustration). 5. Fix the cable securely using cable clamps and run the cable to the base station unit, then connect it to the back.
