User guide

12
1. Microphone
17. Keypad & ringer
tone & ringer tone
on/off
9. FUN: Function
16. Signal strength
statue display
7. MEM: Memory function
15. Phone In-Use
6. END: End the call
14. Key-lock function
operating
13. Battery statue display
4. Placing a call (Line
2/Hold)
12. LCD screen
11. Power switch
10. L: Flash key
2. Number keypad
5. CAL: Intercom Base
or other handset
8. RED: Redial
3. Placing a call (Line 1)
13
HANDSET UNIT OPERATING
INSTRUCTIONS
Press key once to turn the power on. The Handset is in Standby mode
when you see shown on the LCD screen.
Press key for a few seconds until the power off tone is heard.
DIALING A TELEPHONE NUMBER :
Input the telephone number you wish to call for example:
2707 2766
Then press key to connect and dial or press key if you have a second
telephone line connected to the Base Unit (line 2 jack).
ENDING THE TELEPHONE CALL:
Press the key.
RE-DIAL:
To use the Redial function, it is necessary to first connect to the Base Unit and
then enter the telephone number you wish to communicate with. If you do not
get through and wish to re-dial then press the ; then press or
if the second telephone line is connected to the Base Unit (line 2 jack).
However, if you input the telephone number first and then press SND, the redial
function will not be activated.
RECEIVING A CALL:
If the Handset begins to ring, press any key (except the key) to pick up
the incoming phone call.
I
I
ALCON
2
2
7 7
7
6 6
0
1
1
2
END
FUN
SND
RED
I
HANDSET UNIT CONTROL &
FUNCTION KEYS EXPLANATIONS :
1. Microphone 10. L: Flash key
2. Number keypad 11. Power switch
3. Placing a call (Line 1) 12. LCD screen
4. Placing a call (Line 2/Hold) 13. Battery statue display
5. CAL: Intercom Base or other handset 14. Key-lock function operating
6. END: End the call 15. Phone In-Use
7. MEM: Memory function 16. Signal strength statue display
8. RED: Redial 17. Keypad & ringer tone &
9. FUN: Function ringer tone on/off