User guide

OA-2538 HI-GAIN ANTENNA INSTALLATION:

NOTE : It is essential that the outdoor antenna be placed in a strategic area to

provide maximum communication range and clarity.

Before the Base Station and the Handset unit are activated, be sure to

connect the Base Antenna to avoid damage.

AT TACHING THE TWO SECTIONS

1. Connect the two middle wires of each section of the

antenna together.

2. Use the mini-L wrench to fasten the screw given into

the place provided on the middle wire.

3. Dab the glue included around the top 8-10 cms of

the bottom half of the base antenna making sure you

use all the glue.

4. Connect the two sections together as tightly as

possible.

ANTENNA MOUNTING

1. Mount the antenna support, using the U-Clamps

given to an antenna mast (a long thin piece of wood

or metal or fibreglass etc.) to extend the overall

height.

Note: Make sure that the material you use can withstand

any climatic condition.

2. Connect the M-Jacks provided to both ends of the coaxial cable included

(if necessary).

ANTENNA REFLECTOR MOUNTING

3. Screw the three reflectors securely in the bottom part of the antenna into

the places provided.

COAXIAL CABLE MOUNTING

4. Feed the coaxial cable through the support. Mount the high gain antenna

on the support by aligning the holes found on the antenna support with

those found on the antenna. Secure the structure by inserting the screws

into the aligned holes found on the antenna support. Secure the structure

tightly (see illustration).

5. Fix the cable securely on the ground by using cable clamps and run the

cable to the base station unit, then connect it to the coaxial cable plug

located on the back of the base unit.

Note: It is necessary to use the coaxial cable included in our package since

cable specification is compatible with our equipment. Any modification

Bracket

Screw

Antenna support

Nut & washer

U-Clamp

Antenna mast

Antenna

Reflector