User guide

ManualsBrandsALCON ManualsConsumer electronicsAT-3000

FUN 2 RING TONE ADJUST :

Press FUN 2 and 0 to set the ring to “OFF”.

and 1 to set the ring to “LOW”.

and 2 to set the ring to “HIGH”.

WARNING: On the side of the Handset there is an ON/OFF switch to turn off

the sound completely of the unit. If you turn the switch to “OFF”

you will be able to receive incoming calls, but you will not know

since there will be no sound.

FUN 3 DIAL SYSTEM SELECT :

Press FUN 3 # to choose “TONE” mode. This will be shown on the

LCD.

Press FUN 3 * to choose “PULSE” mode. This will be shown on the

LCD.

FUN 4 SCRAMBLER:

There are two scramble functions incorporated into this system SCRB 1 &

SCRB 2. It is necessary that Handset 1 completes this procedure first and then

all the other Handsets follow the same procedure for the Base Unit to accept the

scramble function of any Handset in the system. Also all the Handsets in the

system must be programmed to either SCRB 1 or SCRB 2 for the Base Unit to

accept the scrambled signal. You cannot have some using SCRB 1 and others

using SCRB 2

Press FUN 4 and to cancel the scrambler.

and to set scrambler 1.

and 2 to set scrambler 2.

FUN 5 SERIAL NO. & HANDSET NO. DISPLAY :

FUN 5

This function displays the Serial Number and the Handset Number of the

Handset you are using. The first digits

FUN

MEM

is your Serial Number. The last digit is the Handset Number (from 1-9

depending on how many handsets you have in your system).

PROGRAM NEW HANDSET INTO YOUR SYSTEM FUNCTION:

FUN 6

In the STBY mode press You will see -CODE-- shown on the LCD

Display. Enter the Base Unit Serial Number (5 digits) followed by the Handset

Number you wish to have this Handset be represented by xxxxx x (as shown in

FUN 5). After entering this information, please press MEM to complete this

procedure.

REMEMBER: It is necessary to match the GROUP & TYPE of the new

Handset with the original GROUP & TYPE of Base Unit; otherwise, the

Handset will not be able to link with the Base Unit.

FUN 7:

Adding an Extra Security Code To Your System:

The encode function is another security measure added to your system to further

prevent unwanted use of your system using CTCSS tones for example if one of

your Handsets is stolen and you wish to cancel it from the system. To change the

CTCSS code it is necessary that Handset 1 is the only Handset that can change

this function and the other Handsets will follow it (ie. Handset 1 wishes to

change the CTCSS tone to No. 23. All other Handsets in the system must

change to No. 23 as well, otherwise they will not be able to link). If your

Handset is not Handset 1 (Handset 2-9) and by mistake you change this

function, you will not be able to link with the Base Unit. Unless it is absolutely

necessary, please do not change the factory set CTCSS tone.

Please enter FUN 7 then 01-040 (Handset ID No.) MEM to set your CTCSS

tone.

FUN

MEM

CODE

CODE:23

FUN