User's Manual Part 3

8065751131 3.9

Figure 3-5 Transition from Laser On to

Standby because of a Warning

4.5 Repeat the ﬁ ring procedure as often as necessary, making adjustments to power

output and duration as appropriate to complete the treatment session.

If the system transitions back to Standby mode because of a warning condition, the

parameters section color is changed and a warning message is displayed as shown in

Figure 3-5. This mode change will occur if any of the following events occurs while

the laser is ﬁ ring:

• Standby/Ready button pushed.

• Footswitch unplugged.

• Laser ﬁ ber disconnected from

selected port.

• Remote Interlock disconnected

port.

• Dr. Filter connected, disconnected,

or disengaged.

• System fault.

To resume normal operation,

perform the action(s) displayed in

the warning message.

4.6 When the treatment is completed, release the footswitch and press the Standby/

Ready key. The Standby LED illuminates and the system is placed in standby

mode.

5 TURN OFF SEQUENCE

5.1 Turn the key to the OFF (O) position and, for safety reasons, remove the key.

NOTE: The emergency switch on the front panel should only be used in an

emergency. After using the emergency switch, pull it back to its initial

position to restore power and start the instrument.

5.2 Place the power switch on the rear of the system to the OFF (O) position.