User's Manual Part 3

8065751131 3.11
7 IDENTIFYING UNRECOGNIZED PROBES
If a probe without an identifying RFID tag is connected to the system, a message
appears stating that the system is unable to recognize the probe and prompts the user
to select a probe type (see Figure 3-8).
Figure 3-8 Unidentifiable Probe Display
7.1 Using the Menu Knob, select the type of probe connected to the system. The
system then applies the factory settings for that type of probe. These settings
may be changed in the Fiber Custom Presets display from the Main Menu.
If two unidentifi ed probes are connected when the when the system is turned on,
the display appears for Port 1, which is selected by default. The probe in Port
2 will not require identifi cation until the port is selected. If a probe is inserted
in Port 2 before one is inserted in Port 1, then the Port 2 probe will be the fi rst
selected for identifi cation.
If the laser is in Firing mode and an unidentifi ed probe is connected to the other
port, the Unidentifi ed Probe display will not appear until the user has stopped
fi ring the laser and the port is selected.