User's Manual Part 2

ManualsBrandsAlcon Research ManualsElectronicsPurePoint

2.2

8065751131

LCD Screen

The LCD screen is the communication interface between

the surgeon and the system. It provides the surgeon with

system status and parameters by displaying text and icons

relevant to the current operating state. The background color

of this screen is gray when the system is in the Standby

state and green when is in the Ready state. When the laser is

ﬁ red, "Laser On" is display in a red box at the bottom of the

screen.

Figure 2-2 shows a typical screen that may be displayed on

the LCD. Each screen displayed by the system is described

in detail later in this section. System messages (advisories,

errors, and warnings) are listed in the Troubleshooting

section of this manual.

Laser Ports 1 and 2

Dual SMA connectors are provided on the front panel to connect the

PurePoint™

Laser to the desired delivery system; i.e., Slit Lamp adaptation, Laser Indirect

Ophthalmoscope (LIO), or Endoprobe/Aspirating probe. Each port has an Radio

Frequency Identiﬁ cation (RFID) reader that can identify Alcon RFID enabled probes

and automatically set up the default power and time parameters for the speciﬁ c probe.

Laser ﬁ bers without RFID must be identiﬁ ed by the operator when prompted on the

display.

Port Illumination Ring

The Laser Ports are surrounded by a ring of LED's that provide background

illumination for the port and enable the user to visually verify the following items:

• Indicates that the port is selected.

• Indicates that an unidentiﬁ ed probe has been inserted into the port.

• Indicates that a fault has been detected on the port and the port is no longer

available.

Port Available Illumination Color:

BLUE

If no probe is connected to a port, the Port Illumination Ring is illuminated in the

color blue.

Selected Port Illumination Color:

GREEN

If an identiﬁ ed probe is inserted into the port and the port is selected, the Port

Illumination Ring is illuminated in the color green.

Unidentiﬁ ed Probe Indication Color:

ORANGE

If a probe is inserted into the port and is unidentiﬁ able by the system, the Port

Illumination Ring is illuminated in the color orange, indicating that the probe must be

identiﬁ ed before it can be used.

Figure 2-2

Typical

PurePoint

Screen