User's Manual Part 1

1.12

8065751131

Utility Requirements

Electrical requirement: The

PurePoint™

Laser has a power supply that operates at

100-120 V and 220-240 V input ranges at 50/60 Hz. A properly grounded, standard

plug is the only requirement.

Electrical Connections

CAUTION

Before turning the instrument ON for the ﬁ rst time after receipt of the system, wait one

hour for the components and optics to normalize to avoid possible condensation that

may have occurred during shipping.

Use only <HAR> power cord with a minimum of 10 Amp rating.

Before connecting the main plug verify that:

• The Main Switch on the back panel is in the OFF (O) position.

• The key is in the off (vertical) position, or has been removed.

• The Remote Plug or the interlock cable is connected on the rear panel.

Optical Connections

Optical connections vary in relation to the procedure to be performed. Different

peripherals can be connected to the output ports. These peripherals are:

• Slit Lamp adaptation

• Laser Indirect Ophthalmoscope (LIO)

• Endoprobe/Aspirating Endoprobe/Illuminated Endoprobe

The procedures for connecting these peripherals are contained in Section Three:

Operating Instructions.

Figure 1-5 Remote Connector/Door Lamp Circuit Diagram

REMOTE

CONNECT

9-PIN D-CONNECTOR

CUSTOMER SUPPLIED

DOOR SWITCH (OPTIONAL)

TO DRIVE DOOR LAMP (OPTIONAL)

NONC

COM