User's Manual Part 4

2.94 8065751025
Constellation
®
Vision System
END CASE
The End Case Screen, selected by pressing the End Case tab, displays case related
metrics as shown in Figure 2-71. It is comprised of a Summary panel area and a
tabbed interface area for displaying the various metrics associated with the case. The
screen also provides various controls for renaming the case, printing the End Case
and Laser forms, and customizing the form’s content and layout via the Setup Form
popup.
Figure 2-71 End Case Screen: Anterior Tab
Viewing of the various metrics associated with the case is accomplished by selecting
the associated tabs - Anterior, Posterior, Laser, or Consumables. Pressing the Rename
button above the tabs, displays a keyboard which enables the user to rename the case
from the default name (date of surgery).
The Print and Print Laser Form buttons are used to obtain a print-out of the End
Case Form and Laser Form respectively. The Laser Form is comprised of the End
Case Form’s first header and the Laser metrics table only. Modification of the End
Case Form’s layout and content is accomplished using the Setup Form button. When
pressed, the End Case Form Setup popup is displayed.
End Case Summary Panel
The Summary panel area lists those procedure steps that were used during the case
along with their cumulative times. For a step to be included in the summary list, work
must have been performed using the step. In most cases, work is performed when the
treadle is depressed. Therefore, steps that are defined in the procedure but not actually
used to perform work, are not be listed. This could occur, for example, if the surgeon
used the 1st step of a procedure, selected the 2nd step but did not depress the treadle,
and then proceeded ahead to the 3rd step to perform work. In this scenario, steps 1
and 3 would be included in the summary list, but step 2 would not be included in the
summary since no work was performed with it.