User's Manual Part 4

8065751025 2.91
Constellation
®
Vision System
Cut Rate Progress Bar and Numerical Value - Displays the current cut rate.
Cutting Configuration Button - Displays the configuration popup.
Forceps Panel:
Bimanual On/Off Button - Turning Bimanual mode on allows the control of the
pneumatic forceps while the system is in Scissors mode. All controls function the
same as when the system is in Forceps mode (see Forceps mode for a description).
•
•
•
Figure 2-68 Surgery Screen: Scissors Mode - Proportional
Scissors Mode: PROP SUBMODE
The Proportional submode provides proportional control of the opening and closing
of the scissor blades, dependent upon the amount of footpedal depression. The
amount of scissors closure is indicated in the Pressure panel. When the footpedal is
fully depressed, the Close Limit is reached, and scissors should be fully closed.
Pressing the On/Off button in the Calibration panel displays the Calibration panel that
allows the user to adjust the scissors Start and Close Pressures.
The controls for each panel in Scissors Proportional submode have the following
functions:
Cutting Panel:
Pressure Start Up/Down Buttons - Sets the pressure at treadle start.
Pressure End Up/Down Buttons - Sets the pressure at full treadle.
Pressure Progress Bar and Numerical Value - Displays the current cut rate.
Cutting Configuration Button - Displays the configuration popup.
Calibrate On/Off Button - Enters Calibration Mode allowing the user select and
•
•
•
•
•