User's Manual Part 2

2.30 8065751025
Constellation
®
Vision System
Menu Bar: Options - SYSTEM SETTINGS - REMOTE CONTROL
For information regarding the Remote Control Settings (see Figure 2-6), refer to the
Remote Control description found ealier in this section.
Menu Bar: Options - SYSTEM SETTINGS - VIDEO OVERLAY
The VideoOverlay setting screen shown in Figure 2-19 provides the settings to enable
and setup the VideoOverlay system with the
Constellation
®
Vision System.
Video Overlay - Allows the user determine whether or not Video Overlay is
available. Choices: Enabled or Disabled.
Video Broadcast - Allows the user determine the video format (NTSC or PAL).
Video Connection - Allows the user set the type of cable (S-Video or Composite)
used to connect to the video recording equipment.
Label Opacity - Allows the user determine the opacity of the video overlay output
(range: 0 – 100).
•
•
•
•
Figure 2-19 System Settings - VideoOverlay Screen
Video Recorder - There are no controls for configuring a Video Recorder other than
footswitch mapping that allows the user to start recording and to pause recording
when the footswitch is pressed and also a Video Camera icon that appears in the
upper left hand corner of the Main Constellation
®
screen when the recorder is
recording.
The Video Recorder is a separate user supplied piece of equipment. There are two
video recorders that have been officially approved for use with Constellation
®
Vision
System. The approved recorders are:
Sony Medical Grade DVD Recorder P/N DVO-1000MD
Sony Electronics Inc. - Medical Systems Division
1 Sony Drive, Park Ridge, NJ 07656-8003
Vitec DVD Recorder P/N VMS-3200
Vitec Multimedia Products
2914 Seagull Drive
Duluth, GA 30096
•
•