User's Manual Part 2

8065751025 2.11
Constellation
®
Vision System
Select Remote Control Channel
The remote control can be configured to operate on one of four channels. This feature
allows four remote controls to independently control four Constellation
®
Vision
Systems operating in the same room or area. Remote controls are factory preset to
channel A. For proper remote operation, the Constellation
®
Vision System must be
set to the same channel as the remote.
The Option/System Settings/Remote Control window allows the selection of four
remote receive codes: A, B, C, & D. This selection must correspond to the channel
selection on the remote control. Set the remote channel as instructed below.
To select a remote channel on the Constellation
®
Vision System:
1. Press the Options button to open the Options popup screen.
2. Press the System key to bring up the System Settings screen.
3.
Press the Remote Control tab to display the Remote Control Settings screen (see
Figure 2-6).
4. Hold the remote control in front of the Constellation
®
Vision System display
screen and simultaneously press its parameter value adjustment up/down keys
(labeled 1 & 2 on the screen). Simultaneously release the buttons.
5. On the remote control, press the navigation key corresponding to the new channel
as label in the Remote Control Settings screen.
6. Press the Enter key on the remote, then press Save on the screen.
No additional steps are needed once the remote channel is set, and only one remote
channel is stored per unit.
NOTE: If necessary to distinguish between remote controls, identify the remote
controls and the units with unique labels.
CAUTION
Do not sterilize the remote control as it will damage the unit.
Figure 2-6 Remote Control Channel Selection Screen