User's Manual Part 2

2.10 8065751025
Constellation
®
Vision System
Remote Control Batteries
When the batteries in the remote control are low, the status message “Remote Battery Low”
will appear in a popup dialog the first time a key is pressed after the system is turned on.
The message will disappear after new batteries are installed and a remote control key
is pressed. A battery holder inside the remote holds three (3) AAA (LR3) batteries.
To replace batteries:
Loosen two captive screws on the rear cover with a standard slotted screwdriver
and remove cover.
Replace old batteries and replace cover (correct battery positions are identified
inside each battery slot). When closing the cover it is important that the rubber
buttons slide into the slots in other half of the remote without binding (see Figure
2-5).
To check correct installation of batteries, press a backlight button on the side of
the remote and verify that the remote control buttons illuminate, then turn off
after a few seconds. If illuminated buttons don't turn off, rubber buttons are not
properly inserted into slots, so you must repeat the procedure.
Dispose of batteries following local governing ordinances and recycling plans.
1.
2.
3.
4.
Rubber Buttons(2)
must enter slots
without binding
Figure 2-5 Remote Control Battery Replacement