User guide

Switching handset power on and off
To switch the handset off
(in case you need to save battery power):
Press the
"Power on/off"
button and hold it for 3 seconds
To switch the handset back on:
Notes
If you lift the handset during this time, it will try to link to the base unit.
Make sure mains power to the base unit stays
switched on. The CC2300
cordless handset needs the mains power for the corded base unit to be
turned on to be able to make or receive calls.
When the handset is switched off, it can’t be used for making calls
including emergency calls.
When the handset is switched off, it won’t ring for incoming calls
but the base unit will still ring. To answer a call when the handset
may take a few moments for the handset to re-establish a radio link
with the base unit.
If the batteries have become completely run down (or if handset
is switched off) and you place the handset in the charge cradle,
it may take about 5 minutes to
The handset display will go blank.
Press the
"Power on/off"
button and hold it for 3 seconds or replace
The handset display will turn back on. "BASE 1"
When the handset links with the base, there will be a musical chime,
is switched off , you need to switch it back on. Remember that it
link with the base unit.
!


n
1).
2).
the handset on the charge pod.
n
Notes:
4. Handset basic settings
will flash briefly, while the handset searches for the base.
4
and the handset display will go to idle mode.
To lock the keypad:
Press and hold the button forabout 2 seconds.
To unlock the keypad:

Press and hold the button for
about 2 seconds.
You will hear a beep tone , the icon
will appear on the top of display,
"HS LOCKED"
will flash briefly. While the keypad is locked, if you
press any buttons, the handset will give you a double warning tone, and
"HS LOCKED"
will flash briefly on the display.
You will hear a beep tone , the icon
will disappear from the display and it will
go back to idle mode