Quick Reference Guide

SCRAM CAM
Quick Reference Guide
35
c. Squeeze the shear-cutter handles until the plastic center
breaks and the two pieces separate from the buckle cover.
d. Using the T10 Screwdriver, loosen the two retaining screws.
e. Pull the strap back through the buckle, removing the
bracelet from the client’s ankle.
CLEAN/DISINFECT SCRAM EQUIPMENT
To avoid damaging SCRAM equipment, use only cleaning and
disinfecting products approved by SCRAM Systems as listed below.
NEVER USE CITRUS/PINE-BASED CLEANING PRODUCTS
OR ALCOHOL AND/OR ALCOHOL-CONTAINING CLEANING
PRODUCTS.
APPROVED PRODUCTS
• Sporicidin
®
Disinfectant (USA)
SporeClear™ Disinfectant (outside of USA)
• Windex
®
Multisurface Disinfectant Cleaner (yellow Windex)
Clorox Healthcare
Clorox Healthcare
®
®
- Bleach Germicidal Cleaner
- Bleach Germicidal Cleaner
Cidex OPA
Cidex OPA
®
®
Disinfectant Cleaner
Disinfectant Cleaner
SPORICIDIN/SPORECLEAR
Sporicidin (USA) is available to order online or from SCRAM Systems,
SporeClear (outside of USA) is only available online. Both products
are strongly recommended for disinfecting all SCRAM ankle bracelets.
These are medical-grade disinfectants that do NOT contain alcohol and
kill 100% of disease and odor-causing organisms*.
To disinfect a SCRAM bracelet using either of these products:
1. If the situation warrants, remove the faceplate and bracelet
straps.
2. Spray on and allow surfaces to remain wet for 10 minutes.
3. Rinse with water or wipe surfaces.
4. Dry with a paper towel or cloth.
5. If the bracelet straps were removed, install bracelet straps and
faceplate.
WINDEX
Windex Multisurface Disinfectant Cleaner (yellow Windex) is readily
available at most department stores and home improvement stores. It
does not contain alcohol, is approved for all SCRAM Systems products,
and kills 99.9% of all germs and bacteria*. To disinfect device using
this product:
1. Spray on and allow surfaces to remain wet for 10 minutes.
2. Wipe surfaces dry with a paper towel or cloth.