Quick Reference Guide

SCRAM CAM
Quick Reference Guide
34
» Any remaining data is transferred from the bracelet to
SCRAMNET.
» The bracelet software is checked and updated, if
necessary.
When complete:
After 30 seconds to 2 minutes:
» The
blue light turns off for approximately 5 seconds
then both lights turn back on.
» Bracelet status in the Direct Connect application:
Communication Complete
After 1 minute, the status changes to: Waiting for
Bracelet
The bracelet is now back in inventory and available for
use on another client after being cleaned.
b. Unplug the USB cable from the Direct Connect device and
remove the Direct Connect device from the bracelet.
6. Connect the base station with the Direct Connect application.
Wired SCRAM Base Station Only
a. Plug the power cord into the old base station and into an
electrical outlet.
» Base station display:
Line 1 – DATE/TIME
Line 2 – CHECK PHONE LINE
b. Plug the small (mini-B type) USB connector into the base
station.
At this time:
» Base station status in the Direct Connect application:
Idle -> Communicating
» Base station display:
Line 1 – DIRECT CONNECT
Line 2 – ONLINE
» Any remaining data is transferred from the base station
to SCRAM
NET.
» The base station software is checked and updated, if
necessary.
When complete:
» Base station status in the Direct Connect application:
Communication Complete
» Base station display:
Line 1 – STORAGE MODE
c. Unplug the power cord and USB cable from the base station.
7. Remove the bracelet.
a. On the buckle, place the shear cutter tips into the two holes
where the tamper clips meet.
b. Press down rmly.