Quick Reference Guide

SCRAM CAM

CLOSING TASKS

CHECK IN SCRAM EQUIPMENT

WHEN CLIENT ARRIVES

Perform the following steps when the client arrives to be removed from

the SCRAM Systems Program.

1. Set the SCRAM equipment to Pending Removal.

a. Access the client’s Equipment page.

b. If a MultiConnect AW wireless device is assigned to the

client, click the Remove MultiConnect link to unassign the

wireless device.

c. Click the Stop Monitoring button and complete the

process.

The status of the SCRAM equipment is set to Pending

Removal.

Note: If a wireless SCRAM Base Station is being unassigned,

the status of that device is immediately set to In Inventory.

2. Log into the Direct Connect application.

a. Open the Direct Connect application.

b. Log into the Direct Connect application using your SCRAM

NET

username and password.

3. Connect the Direct Connect device with the Direct Connect

application.

a. Plug the small (mini-B type) USB connector into the Direct

Connect device.

b. Plug the large (A type) USB connector into a USB port on

your computer.

The

red and blue lights on the Direct Connect device blink

for approximately 5 seconds then both remain on.

Bracelet status in the Direct Connect application: Waiting for

Bracelet

4. Attach the Direct Connect device to the bracelet.

a. Align the Direct Connect device with the top of the bracelet.

b. Slide the Direct Connect device down over the bracelet.

5. Wake up the bracelet.

a. Momentarily place the magnet on the Direct Connect device

where the word “magnet” appears.

At this time:

» Bracelet status in the Direct Connect application:

Communicating

» On the Direct Connect device, the

red light turns off

while the blue light remains on.