Quick Reference Guide
SCRAM CAM
Quick Reference Guide
31
» The bracelet software is checked and updated, if
necessary.
When complete:
» The
blue light turns off for approximately 5 seconds
then both lights turn back on.
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 10 seconds, the status changes to: Waiting
for Bracelet
b. Remove the Direct Connect device from the bracelet.
5. Connect the base station with your computer.
Wired SCRAM Base Station Only
a. Plug the power cord into the new base station and into an
electrical outlet.
» Base station display:
◊ Line 1 – STORAGE MODE
◊ Line 2 – BATTERY CHARGED
b. Plug the small (mini-B type) USB port into the base station.
At this time:
» Base station status in the Direct Connect application:
Idle -> Communicating
» Base station display:
◊ Line 1 – DIRECT CONNECT
◊ Line 2 – ONLINE
The base station assignment process begins.
1) Any remaining data is transferred from the base station
to SCRAM
NET.
2) The base station software is checked and updated, if
necessary.
3) Client parameters are loaded on the base station.
When complete:
» Base Station status in the Direct Connect application:
Communication Complete
» Base station display:
◊ Line 1 – TIME/DATE
◊ Line 2 – MONITORING
c. Unplug the power cord and USB cable from the base station.
6. Give the base station to the client.
Wired SCRAM Base Station
Include the:
• Phone cable if analog phone line being used.
• MultiConnect AW wireless device and device power cord if
cellular network being used.
• Ethernet cable if Internet being used.