Quick Reference Guide

SCRAM CAM
Quick Reference Guide
30
uploaded to SCRAMNET using either cellular or WI-FI services.
Internet Service
To use the ethernet port on the base station, using the proper
tool such as needle-nose pliers, carefully remove the clear, plastic
plug from the Ethernet port. Damage may occur if the plug is
improperly removed. If the client has an Internet modem or
router installed, use an Ethernet cable to connect the base station
to an available network port to send data back to SCRAM
NET
using the client’s Internet service.
Important Note: AMS has no control over the reliability of the
client’s Internet service and AMS Customer Services should NOT
be contacted if Internet services are interrupted. It is the client’s
responsibility to contact his/her Internet Service Provider should
an interruption occur.
Analog Phone Line
An analog phone line can be used to transmit client data to
SCRAM
NET.
Wireless
The MultiConnect AW wireless device can be used to transmit the
client’s data to SCRAM
NET using a cellular network. Two versions
of the device are available for your use. Both function in the same
way using two generations of wireless communication technology.
Direct Connect
In some cases, you may want the client to come in to the offi ce
on a regular basis for a face-to-face meeting. In this situation,
Direct Connect can be used during that meeting to upload the
client’s data. Direct Connect must be used if the three previous
communication methods cannot be used. There is no need to
assign a base station if Direct Connect is going to be used to
upload data.
2. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
3. Attach the Direct Connect device to the bracelet.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the Direct Connect device down over the bracelet.
4. Wake up the bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word “magnet” appears.
At this time:
» Bracelet status in the Direct Connect application:
Communicating
» On the Direct Connect device, the
red light turns off
while the
blue light remains on.
» Data is transferred from the bracelet to SCRAM
NET.