Quick Reference Guide

SCRAM CAM
Quick Reference Guide
25
b. Feed the strap through the buckle and completely tighten.
The bracelet should be able to be rotated slightly, but not
past the shin bone.
Important Note: To properly align the bracelet strap,
ensure that the tooth alignment tab is positioned between
two teeth when the buckle is tightened. For a CAM+HA
client, an “Open Strap Detected” event will be generated if
the strap is not properly aligned.
c. Using the T10 screwdriver, tighten the retaining screws until
the two sides of the buckle are fl ush.
3. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
4. Connect the Direct Connect device with your computer.
a. Plug the small (mini-B type) USB connector into the Direct
Connect device.
b. Plug the large (A type) USB connector into a USB port on
your computer.
The
red and blue lights on the Direct Connect device blink
for approximately 5 seconds then remain on.
Bracelet status in the Direct Connect application: Waiting for
Bracelet
5. Attach the Direct Connect device.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the Direct Connect device down over the bracelet.
6. Wake up the bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word “magnet” appears.
At this time:
» Bracelet status in the Direct Connect application:
Communicating
» On the Direct Connect device, the
red light turns off
while the blue light remains on.
» Data is transferred from the bracelet to SCRAM
NET.
» The bracelet software is checked and updated, if
necessary.
When complete:
» The
blue light turns off for approximately 5 seconds
then both lights turn back on.
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 10 seconds, the status changes to: Waiting
for Bracelet
b. Remove the Direct Connect device.