Quick Reference Guide
SCRAM CAM
Quick Reference Guide
24
b. Slide the Direct Connect device down over the bracelet.
11. Wake up the bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word “magnet” appears.
Bracelet status in the Direct Connect application:
Communicating
On the Direct Connect device, the
red light turns off while
the blue light remains on.
At this time:
1) The bracelet initialization process begins.
2) The initial alcohol reading is uploaded to SCRAM
NET.
When complete:
» The
blue light on the Direct Connect device turns off
for approximately 10 seconds then both lights turn
back on.
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 1 minute, the status changes to: Waiting
for Bracelet
b. Remove the Direct Connect device from the bracelet.
12. Verify that re-initialization has started.
a. In SCRAM
NET, access the client’s Reports page.
b. Click the Communication sub-tab.
c. Verify by looking at the current top Date/Time link that the
base station has recently communicated with SCRAM
NET.
d. Open the communication and verify that a “Initial Baseline
Reading Taken” message appears.
e. If the message does NOT appear, contact AMS Customer
Services.
13. Insert the tamper clips into the buckle slots and squeeze together
until you hear a distinct click.
RE-INITIALIZE SCRAM CAM BRACELET
1. Complete the Bracelet Maintenance process.
a. Access the client’s Equipment page.
b. Click the Maintenance link.
c. Select the check box that represents the bracelet
maintenance activity that was just completed.
d. Click the Complete Bracelet Maintenance button.
The re-initialization will begin the next time that the bracelet
communicates with SCRAM
NET using Direct Connect.
2. Attach the bracelet to the client.
a. Place the bracelet no more than an index fi nger above the
right or left ankle with the SERIAL NUMBER FACING UP.