Quick Reference Guide

SCRAM CAM
Quick Reference Guide
23
and pushing down on the negative (fl at) side, which faces up
towards the serial number.
A small,
green light on the bracelet will turn on for 5
seconds.
6. Install the new faceplate.
a. Place the faceplate on the bracelet with the battery side
fl ush with the case.
Note: The faceplate is designed to align in only one
direction.
b. Starting on the top-right side and going clockwise, press
down fi rmly on each corner of the faceplate with your
thumb.
You should hear a pronounced click as you push each corner
of the faceplate.
Warning: Moisture may enter under the faceplate if these
instructions are NOT followed.
7. Attach the bracelet to the client.
a. Open the bracelet.
b. Place the bracelet no more than an index fi nger above the
right or left ankle with the SERIAL NUMBER FACING UP.
c. Feed the strap through the buckle and completely tighten.
The bracelet should be able to be rotated slightly, but not
past the shin bone.
Important Note: To properly align the bracelet strap,
ensure that the tooth alignment tab is positioned between
two teeth when the buckle is tightened. An “Open Strap
Detected” event will be generated if the strap is not properly
aligned.
d. Tighten the retaining screws until the two sides of the buckle
are fl ush.
8. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
9. Connect the Direct Connect device with your computer.
a. Plug the small (mini-B type) USB connector into the Direct
Connect device.
b. Plug the large (A type) USB connector into a USB port on
your computer.
The
red and blue lights on the Direct Connect device blink
for approximately 5 seconds then both remain on.
Bracelet status in the Direct Connect application: Waiting for
Bracelet
10. Attach the Direct Connect device to the bracelet.
a. Align the Direct Connect device with the top of the bracelet.