Quick Reference Guide
SCRAM CAM
Quick Reference Guide
16
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 1 minute, the status changes to: Waiting for
Bracelet
b. Remove the Direct Connect device.
5. Remove the old bracelet.
a. On the buckle, place the shear cutter tips into the two holes
where the tamper clips meet.
b. Press down fi rmly.
c. Squeeze the shear cutter handles until the plastic center
breaks and the two pieces separate from the buckle cover.
d. Using the T10 Screwdriver, loosen the two retaining screws.
e. Pull the strap back through the buckle, removing the
bracelet from the client’s ankle.
6. Attach the new bracelet to the client.
a. Place the bracelet no more than an index fi nger above the
right or left ankle with the SERIAL NUMBER FACING UP.
b. Feed the strap through the buckle and completely tighten.
The bracelet should be able to be rotated slightly, but not
past the shin bone.
Important Note: To properly align the bracelet strap,
ensure that the tooth alignment tab is positioned between
two teeth when the buckle is tightened. An “Open Strap
Detected” event will be generated if the strap is not properly
aligned.
c. Tighten the retaining screws until the two sides of the buckle
are fl ush.
7. Attach the Direct Connect device to the new bracelet.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the device down over the bracelet.
8. Wake up the new bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word “magnet” appears.
At this time:
» Bracelet status in the Direct Connect application:
Communicating
» On the Direct Connect device, the
red light turns off
while the blue light remains on.
» Any remaining data is transferred from the bracelet to
SCRAM
NET.
» The bracelet software is checked and updated, if
necessary.
» Client data is downloaded to the bracelet.
When complete: