Quick Reference Guide
SCRAM CAM
Quick Reference Guide
15
REPLACE SCRAM CAM BRACELET
BEFORE MEETING CLIENT
Perform the following steps shortly before meeting with the client.
1. Select a new bracelet in SCRAM
NET.
The status of the new bracelet is set to Pending Assignment and
the status of the old bracelet is set to Pending Removal.
2. Install the bracelet components.
WHEN CLIENT ARRIVES
1. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
2. Connect the Direct Connect device with your computer.
a. Plug the small (mini-B type) USB port into the Direct
Connect device.
b. Plug the large (A type) USB connection into a USB port on
your computer.
The
red and blue lights on the Direct Connect device blink
for approximately 5 seconds then both remain on.
Bracelet status in the Direct Connect application: Waiting for
Bracelet
3. Attach the Direct Connect device to the old bracelet.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the Direct Connect device down over the bracelet.
4. Wake up the old bracelet.
a. Momentarily place the magnet on the top right side of the
bracelet.
At this time:
» Bracelet status in the Direct Connect application:
Communicating
» On the Direct Connect device, the
red light turns off
while the blue light remains on.
» Any remaining data is transferred from the bracelet to
SCRAM
NET.
» The bracelet software is checked and updated, if
necessary.
When complete:
After 30 seconds to 2 minutes:
» The
blue light on the Direct Connect device turns off
for approximately 5 seconds then both lights turn back
on.