Quick Reference Guide

SCRAM CAM
Quick Reference Guide
10
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 1 minute, the status changes to: Waiting
for Bracelet
b. Remove the Direct Connect device from the bracelet.
8. Connect the base station with the Direct Connect application.
Wired SCRAM Base Station Only
a. Plug the power cord into the new base station and into an
electrical outlet.
» Base station display:
Line 1 – TIME/DATE
Line 2 – CHECK PHONE LINE
b. Plug the small (mini-B type) USB connector into the base
station.
At this time:
» Base station status in the Direct Connect application:
Idle -> Communicating
» Base station display:
Line 1 – DIRECT CONNECT
Line 2 – ONLINE
» Any remaining data is transferred from the base station
to SCRAM
NET.
» The base station software is checked and updated, if
necessary.
When complete:
» Base station status in the Direct Connect application:
Communication Complete
» Base station display:
Line 1 – TIME/DATE
Line 2 – MONITORING
c. Unplug the power cord and USB cable from the base station.
CLIENT MEETING IN JAIL/REMOTE SETTING
Perform the following steps when you meet with the client in a jail/
remote setting.
1. Determine the communication method.
Cellular/WI-FI
The wireless SCRAM Base Station allows data to be quickly
uploaded to SCRAM
NET using either cellular or WI-FI services.
Internet Service
To use the ethernet port on the base station, using the proper
tool such as needle-nose pliers, carefully remove the clear, plastic
plug from the Ethernet port. Damage may occur if the plug is
improperly removed. If the client has an Internet modem or
router installed, use an Ethernet cable to connect the base station