Quick Reference Guide

SCRAM CAM
Quick Reference Guide
9
ASSIGN SCRAM EQUIPMENT - REMOTE/JAIL
BEFORE MEETING CLIENT
Perform the following steps shortly before meeting with the client.
1. If you have the client’s information available, enter that
information into SCRAM
NET using the Add New Client page.
2. Ensure that the wired or wireless SCRAM Wireless Base Station is
fully charged.
3. Install the bracelet components.
4. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
5. Connect the Direct Connect device with the Direct Connect
application.
a. Plug the small (mini-B type) USB connector into the Direct
Connect device.
b. Plug the large (A type) USB connector into a USB port on
your computer.
The
red and blue lights on the Direct Connect device blink
for approximately 5 seconds then both remain on.
Bracelet status in the Direct Connect application: Waiting for
Bracelet
6. Attach the Direct Connect device to the bracelet.
CAM ONLY - Ensure that the bracelet straps are NOT connected.
CAM+HA - Feed the strap through the buckle and completely
tighten.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the Direct Connect device down over the bracelet.
7. Wake up the bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word “magnet” appears.
At this time:
» Bracelet status in the Direct Connect application:
Communicating
» On the Direct Connect device, the
red light turns off
while the blue light remains on.
» Any remaining data is transferred from the bracelet to
SCRAM
NET.
» The bracelet software is checked and updated, if
necessary.
When complete:
» The blue light turns off for approximately 5 seconds
then both lights turn back on.