Quick Reference Guide
SCRAM CAM
Quick Reference Guide
8
At this time:
1) The bracelet initialization process begins.
2) The initial alcohol reading is uploaded to SCRAM
NET.
When complete:
» The
blue light on the Direct Connect device turns off
for approximately 10 seconds then both lights turn
back on.
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 1 minute, the status changes to: Waiting
for Bracelet
b. Refresh the client’s Equipment page to confi rm that the
status of the bracelet is now set to Assigned to Client.
c. Remove the Direct Connect device from the bracelet.
9. Insert the tamper clips into the buckle slots and squeeze together
until you hear a distinct click.
10. If the client is going to be monitored for house arrest in addition
to alcohol abstinence, connect the base station with the Direct
Connect application.
Wired SCRAM Base Station Only
a. Plug the power cord into the new base station and into an
electrical outlet.
b. Plug the small (mini-B type) USB connector into the base
station.
At this time:
» Base station status in the Direct Connect application:
Idle -> Communicating
» Any remaining data is transferred from the base station
to SCRAM
NET.
» The base station software is checked and updated, if
necessary.
When complete:
» Base station status in the Direct Connect application:
Communication Complete
c. Unplug the power cord and USB cable from the base station.
11. Have the client sign the participant agreement.
12. Give the base station to the client.
Wired SCRAM Base Station
Include the:
• Phone cable if analog phone line being used.
• MultiConnect AW wireless device and device power cord if
cellular network being used.
• Ethernet cable if Internet being used.
Wireless SCRAM Base Station
Give the client a copy of the “Install Wireless SCRAM Base Station
at Monitoring Location” quick sheet. The quick sheet is available
on the SCRAM
NET Help page.