Quick Reference Guide

SCRAM CAM
Quick Reference Guide
4
Important Note: To properly align the bracelet strap,
ensure that the tooth alignment tab is positioned between
two teeth when the buckle is tightened.
5. Log into the Direct Connect application.
a. Open the Direct Connect application.
b. Log into the Direct Connect application using your SCRAM
NET
username and password.
6. Connect the Direct Connect device with your computer.
a. Plug the small (mini-B type) USB connector into the Direct
Connect device.
b. Plug the large (A type) USB connector into a USB port on
your computer.
The
red and blue lights on the Direct Connect device blink
for approximately 5 seconds then both remain on.
Bracelet status in the Direct Connect application: Waiting for
Bracelet
7. Attach the Direct Connect device to the bracelet.
a. Align the Direct Connect device with the top of the bracelet.
b. Slide the Direct Connect device down over the bracelet.
8. Wake up the bracelet.
a. Momentarily place the magnet on the Direct Connect device
where the word “magnet” appears.
Bracelet status in the Direct Connect application:
Communicating
On the Direct Connect device, the
red light turns off while
the blue light remains on.
At this time:
1) The bracelet initialization process begins.
2) The initial alcohol reading is uploaded to SCRAM
NET.
When complete:
» The
blue light on the Direct Connect device turns off
for approximately 10 seconds then both lights turn
back on.
» Bracelet status in the Direct Connect application:
Communication Complete
Note: After 1 minute, the status changes to: Waiting
for Bracelet
b. Refresh the client’s Equipment page to confi rm that the
status of the bracelet is now set to Assigned to Client.
c. Remove the Direct Connect device from the bracelet.
9. Insert the tamper clips into the buckle slots and squeeze together
until you hear a distinct click.
10. Connect the base station with the Direct Connect application.
Wired SCRAM Base Station Only