Alcohawk® Micro Owner’s Manual ©2005 Q3 Innovations, LLC
TABLE OF CONTENTS INTRODUCTION Overview of the Alcohawk® Micro Alcohol Testing Theory Description of Testing System Dose-Specific Effects of Alcohol Intoxication Uses of Breath Alcohol Screening Devices 1 1 1 2 2 4 PREPARATION Installing the Battery Opening the Mouthpiece 4 4 5 COMPONENTS DIAGRAM 6 OPERATION Operating Instructions Error Messages Understanding the Results Precautions 6 6 8 8 9 SPECIFICATIONS 10 VERIFICATION AND CALIBRATION Overview Procedure 11 11 11 WARRANTY 11 DISCLAIMER 14
INTRODUCTION Overview of the Alcohawk® Micro The Alcohawk® Micro is a breath alcohol tester designed to test for the presence of alcohol in the blood. This device provides a digital reading of an individual’s approximate blood alcohol concentration (BAC) in seconds. The Alcohawk® Micro is powered by one AAA battery that generally lasts between 200-300 tests. To fully utilize this device to its potential, we recommend reading this entire manual.
Some states prohibit driving with a .08% BAC or above reading, and in many states, individuals can be prosecuted for driving under the influence at any level. Some states also prohibit driving commercial vehicles or any vessel with .04% or more. There is no safe way to drive under the influence of alcohol. Even one drink can make you unsafe. BAC Dose-Specific Effects2 0.02-0.03%3 Generally no loss of coordination, slight euphoria or loss of shyness. Depressant effects are not apparent.
COMPONENTS DIAGRAM Opening The Mouthpiece FOLDING MOUTHPIECE Pull up on the folding mouthpiece located on the top of the unit until the mouthpiece extends straight up from the unit. If testing multiple individuals, it is suggested to place a tight fitting straw over the mouthpiece each time for sanitary purposes. See diagram below.
3) Take a DEEP BREATH AND BLOW STEADILY (for at least 5 seconds) until a BEEP sounds to signal completion of the testing. Note: The unit will start to beep when you blow and will continue until testing is completed and a louder beep sounds. Error Messages Error Message PL Note: The unit will display a 0 after approximately 1 – 2 seconds if a trace level of alcohol is not detected in the breath sample (i.e., at least 0.001% BAC). RP 4) READ THE RESULTS (NEVER DRINK AND DRIVE). Reading .02-.03% .04-.
SPECIFICATIONS Precautions 1. After drinking, smoking and eating, users should wait at least 20 minutes before testing. 2. Avoid testing in strong winds, in a closed room with a heavy amount of smoke, or where a lot of alcohol is being consumed. 3. When the red light is blinking continuously during testing phase, replace the AAA battery. 4. Do not blow cigarette smoke, food or liquid into the instrument because this may damage the sensor. 5.
VERIFICATION AND CALIBRATION Overview Verification is a procedure using an advanced Alcohol Breath Test Simulator that verifies whether the unit is displaying the specific BAC level. If the verification procedure determines that the BAC is not consistent with actual BAC levels, calibration of the device is performed by using an advanced Alcohol Breath Test Simulator.
instructions. Remember to return the device postage paid, insured and in suitable packaging. 2. For your own protection, obtain a proof of delivery receipt. Shipping costs are your responsibility. 3. You must enclose with the unit the following information: a. Your name, complete return address and written description of the problem. (No PO Box please.) b. A telephone number where you can be reached during normal business hours. c. A copy of your dated sales receipt or invoice.
NOTES DO NOT DRINK ALCOHOL AND DRIVE ALWAYS USE A DESIGNATED DRIVER AFTER DRINKING ALCOHOL BE SAFE AND DRINK RESPONSIBLY Q3 Innovations, LLC www.q3i.
Q3 INNOVATIONS, LLC Innovators of Intelligent Technology www.q3i.
