Instruction manual

16) When using two piece fasteners, (i.e..
Pin and Collar type), the
conical/chamfered end of the collar MUST
always be towards the Nose assembly,
NOT against the work piece.
17) Keep fingers clear from the underside
of the head, collars and blind side of
fasteners and from within the joint being
fastened, during the installation cycle.
18) Do not look directly at the head or
blind side of fasteners during the
installation cycle.
19) During the installation cycle, the tool
will pull and straighten itself to the axis of
the fastener, beware of hands being
trapped against any nearby structure.
KEEP HANDS CLEAR
20) In the event of any difficulty whilst
installing a fastener, releasing the tool
trigger at any time during the installation
cycle will immediately put the tool into
reverse.
Note
The following symbols are attached to the equipment:
The equipment ,meets the
requirements of CE
Certification.
Read the Instruction Manual
before using or maintaining
this equipment.
Wear eye protection
when using this
equipment.
21) Beware of fastener Pintails which are
ejected, (sometimes forcibly), from the
tool at the completion, or at Pintail
fracture, during the installation cycle.
Tools designed to have Pintail
Deflectors and or catchers must never
be used without them.
22) Do not continue to use any
equipment which develops a fault whilst
being used.
23) Avoid kinking of hoses or dragging of
hoses and electrical cables over sharp
objects.
!""#$%&'()*+$,()*(-$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$./0&1$21-3(4*4+$,5-3(6-