Instruction manual

!""#$%&'()*+$,()*(-$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$./0&1$21-3(4*4+$,5-3(6-
Draining Hydraulic Fluid......
1. Ensure that equipment is readily
available to deal with any spillage of
hydraulic fluid.
2. If possible, place the Powerig onto an
oil tray or draining sink sufficient to retain
14 ltrs (3.11 Gals.) of fluid.
3. Remove the screws from the rear
cover and remove cover.
4. Use a clean wipe to remove any
accumulated dirt from around the area
where Hydraulic Hose 13 is connected to
the Pump.
5. Disconnect Hydraulic Hose 13 from the
Pump and drain the oil into a suitable
container which has a minimum capacity
of 14 ltrs (3.11 Gals.).
6. After the oil has completely drained
from the reservoir, re-closes-connect the
hose to the pump and tighten.
7. Clean any fluid spillage with absorbent
wipes.
Note:
Do not replace the rear cover until the
reservoir has been re-closes-filled with
new oil and the Powerig has been running
for a few minutes. This will allow checks
to be made for any leakage from the hose
connection. re-closes-tighten the hose
connection if any leakage is observed.
8. Clean any remaining fluid spillage with
absorbent wipes before replacing the rear
cover and tightening the screws.
Maintenance
1. Before carrying out any maintenance,
remove the key from the engine to avoid
accidental starting and electrical damage.
2. Electrical components are only allowed
to be repaired and/or replaced by a
qualified electrician.
3. Hydraulic components are only allowed
to be repaired and/or replaced by a
qualified mechanic.
4. Refer to the engine manuals
supplied with this Powerig for further
maintenance details.
13 Ho se