Instruction manual

Anvil, closing around the end of Pin. The
Anvil will be forced forward toward the
Collar Flange to complete the Collar
swaging/forming.
10. Release the tool Trigger when the
Collar is fully swaged or the Nose
Assembly stops moving. When the Nose
Assembly Anvil is free from the Collar, the
Puller will release from the end of the Pin
and enable the Tool/Nose Assembly to be
removed from the installed fastener.
11. The installed fastener should be
checked with a Bobtail Fastener
inspection Gauge to ensure correct Collar
swage. Adjust the Main Pressure Relief
Valve if necessary.
Note:
Set a Pull Pressure just above the minimum
pressure required for the Nose Assembly
Anvil to just lightly contact the Collar
Flange. A circular witness mark around the
Collar flange will indicate the Anvil contact.
On most large diameter (12 mm (1/2”) and
above), Bobtail Collars have a series of
raised nodules around the flange which will
be crushed by contact with the Anvil.
Do not adjust the Pull Pressure too high as
this increases the risk of Bobtail grooves
being stripped/damaged or the Bobtail
portion of the pin being broken away from
the pin. In either event, this will prevent a
Bobtail Collar Cutter from being used to
remove the installed fastener
Other tools used to install Pintail type
fasteners...
The Powerig Pull and Return Pressures
should be set in accordance with the
information in the Instruction Manual for
!""#$%&'()*+$,()*(-$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$./0&1$21-3(4*4+$,5-3(6-
Preparation for Regular Use
Before each Powerig operation, perform
the following:
1. Inspect hoses, electrical cords and
connections frequently for signs of
damage or ageing. If necessary replace.
2. Regularly check engine oil level and
hydraulic fluid level.
3. Connect the Pull and Return Hydraulic
Connectors of the Tool or Hose Set to the
Powerig Hydraulic Connectors 18 & 19.
Connect the Electrical Plug of the Tool or
Hose Set to the Powerig connection 34 or
35 according to the tool being used.
4. Check that all electrical and hydraulic
connectors of the Tool and Hose Sets are
properly attached.
5. Cycle the Tool several times to
circulate the oil through the Powerig
valves, hoses and Tool.
CAUTION
Do not attempt to operate the Tool
without the Tool hoses attached to the
Powerig. When using HPT tools,
release trigger immediately at the end
of the pull stroke.
8. Powerig is ready for use.