Instruction manual

Huck-Spin® Series Tooling (HK1076) Alcoa Fastening Systems
33
Actuator Disk and Rod Assembly
45. Apply 2 drops of Loctite to threads of actu-
ator rod.
46. Screw actuator disk onto actuator rod until
rod shoulder seats tightly against disk face.
Follow directions on bottle, and allow
Loctite to “set” for best results.
Actuator Rod Assembly; Conical Spring;
Drive Shaft
47. From rear, slide actuator rod through
internal drive gear. NOTE: “Keyway” of
actuator disk must be aligned with actua-
tor disk key.
48. Slide conical spring into central gear hous-
ing against actuator disk. Place end cap
against spring and push into counterbore of
housing. Use TRUARC
®
pliers to install
retaining ring.
49. Apply grease to both ends of drive shaft
and piston counterbore. Slide drive shaft
through bore of piston, and engage shaft
drive with internal drive gear.
A
A
SSEMBLY
SSEMBLY
(
(
CONTINUED
CONTINUED
)
)
CAUTION: Be sure counterbored area of
piston is greased.
TRUARC is a trademark of TRUARC Co. LLC