Instruction manual

Handle and Cylinder Assembly
33. Attach one Handle half to Cylinder. Where
used, position optional secondary switch
and wiring in Handle.
34. Attach other Handle half to Cylinder, and
install remaining Handle screws.
35. Attach Suspension Bracket to Handle.
(Figure 35)
36. Install Handle and Cradle Assembly.
Cylinder and Gear Housing/Drive
Mounting Flange Assembly
37. Carefully slide Electrical Cord through
appropriate slot of drive mounting flange.
38. When cord is properly routed, engage pilot
bore of flange, and align bolt holes of cylin-
der and flange in required orientation.
39. Apply one drop of removable Loctite to
both retainaing screws, and tighten to speci-
fication.
Trigger Cord and Power Cord to
Terminal Block; Limit Switch Cover
40. Place spacers and circuit board in position,
and attach 3 standoffs.
41. Connect wires of trigger cord and wires of
power cord to appropriate terminals of ter-
minal block.
42. Place switch actuator slide and spring in
position, holding in place while attaching
cover.
43. While holding down cover to prevent loss
of spring, attach limit switch cover with 3
screws.
Front Air Motor Drive; Air Lines
44. Press on fitting with ; push tubing ing in;
then release thumb pressure.
Huck-Spin® Series Tooling (HK1076) Alcoa Fastening Systems
32
Position Bracket
to obtain best
balance with
required
Nose Assembly
Position Screw
to prevent
rotation of
Bracket.
Handle
Halves
Figure 35
A
A
SSEMBLY
SSEMBLY
(
(
CONTINUED
CONTINUED
)
)
CAUTION: Be careful not to pinch the
electrical cord.