Instruction manual

Huck-Spin® Series Tooling (HK1076) Alcoa Fastening Systems
30
15. Using Pin Spanner Assembly, screw
Cylinder End Cap onto Cylinder, and tight-
en until Cap bottoms on Cylinder. (Figure
28)
16. Remove Piston Assembly Tool and Pin
Spanner Assembly.
17. Thread Hoses onto Cylinder as shown in
Figures 7a, 7b, and 14. (Screw Hose with
male nipple into port “P” of Cylinder, and
hose with female coupler into port marked
“R”.) Rub Slic-Tite
®
TEFLON
®
thread
compound, or equivalent, on pipe threads to
prevent leaks and for ease of assembly.
Internal Drive Gear & Bearing Assembly
18. Pack Bearing with bearing grease, press it
into shoulder of Internal Drive Gear, and
install Retaining Rings. (Figure 33)
19. Grease Bearing and Gear assembly, and
press it into Gear Housing.
20. Install Actuator Disk Key in housing. Apply
Loctite
®
to both screws and tighten to spec-
ification.
Intermediate Drive Gear & Bearing Assy;
Drive Mounting Flange (Figure 33)
21. Pack Bearings with bearing grease and
press flush into Intermediate Gear.
22. While pushing Shaft through motor boss,
install Intermediate Gear and Spacers, and
tighten Shaft Locking Screw against Shaft.
23. Attach Drive Mounting Flange to central
Housing with eight Screws. Apply blue
Loctite to threads and tighten to specifica-
tion.
Ball Bearing
Retaining Ring
(Spirolox type)
Retaining Ring
(Truarc type)
Internal Drive Gear
Actuator
Disk Key
Screws
Shaft
Intermediate Gear
Spacer
Bearing
Shaft
Locking
Screw
Screws
Drive Mounting Flange
Figure 33
A
A
SSEMBLY
SSEMBLY
(
(
CONTINUED
CONTINUED
)
)
CAUTION: Do not use TEFLON
®
tape on
pipe threads. Pipe threads may cause tape
to shred resulting in tool malfunction.
(Slic-Tite is available in stick form as Huck
P/N 503237.)
Slic-tite is a registered trademark of LA-CO Industries, Inc.
TEFLON is a registered trademark of E. I. du Pont de Nemours and Company
Loctite is a registered trademark of Henkel Corporation, U.S.A.