Instruction manual

Huck-Spin® Series Tooling (HK1076) Alcoa Fastening Systems
24
16. Remove Gear Cover (22n), and
push Drive Gear Bushing (22h)
out of cover. (Figure 19)
17. Unscrew four remaining Motor
Mount Screws (22d), andLift
Motor Mount (22c) away from
Central Housing (22s).
18. With a large screwdriver
through the bottom of the
Motor Mount, carefully pry the
Drive Gear (22f) off the Motor
Shaft (Figure 20).
19. Slide Spacer (22j) off Motor
Shaft.
20. Unscrew four Screws
(22d) holding Motor to
Motor Mount.
LIFT
LIFT
22d
(4)
22c
22s
22h 22n
(Front Motor
model shown)
Figure 19
Rear Motor Models
(Figure 21)
21. Using hex key, remove
Trigger Switch Assembly
(18) from Motor.
22. Loosen Set Screw, and
remove Trigger Switch
from Switch Holder.
Using a screwdriver,
remove wires from
Switch.
22f22j
Carefully pry the Drive
Gear (22f) off the Motor
Shaft with tip of screwdriver.
Motor
Shaft
22d
(4)
Figure 20
Screw
Switch Holder
Clamp side
Switch Holder
Switch side
Setscrew
Trigger
Assembly
2-Conductor
Wire
Figure 21
D
D
ISASSEMBLY
ISASSEMBLY
(
(
CONTINUED
CONTINUED
)
)