Quick Start Guide CJB26QAALAAA
Welcome! This manual brief is the profile of your USB-Modem, about the details of how to set the management parameters, see help information on management page. www.sar-tick.com This product meets applicable national SAR limits of 2.0W/kg. The specific maximum SAR values can be found in the following section of this user guide.
Getting to Know Your Modem 1. USB Interface 2. Cap 3. Strap Hole 4. Indicator LED 5.
Note: You can tie the cap and modem by threading a strap through the strap hole to avoid cap missing.
How to start your modem 1. 2. 3. 4. Remove the cap from the USB modem. Insert the SIM/UMSIM card into card slot on back of modem. Insert the USB modem into computer’s USB port. After the program is installed, a shortcut icon for the management program appears on the desktop. You can also double-click the shortcut icon on the desktop to start the management program. Note: Do not remove the SIM/USIM card when the card is in use. If the modem does not be installed automatically, find the AutoRun.
LED Indicates (Following table are listed the LED Indicates for each status.
Safety and Use We recommend that you read this chapter carefully before using the USB-Modem. The manufacturer disclaims any liability for damage, which may result as a consequence of improper use of the USB-Modem or of use contrary to the instructions contained herein. Traffic Safety When driving, do not use the USB-Modem When switched on, the USB-Modem emits electromagnetic waves that can interfere with the vehicle’s electronic systems such as ABS anti-lock brakes or airbags.
Conditions of Use Switch the USB-Modem off before boarding an aircraft. Switch the USB-Modem off when you are in health care facilities, except in designated areas. As with many other types of equipment now in regular use, the USB-Modem can interfere with other electrical or electronic devices, or equipment-using radio frequencies. Switch the USB-Modem off when you are near gas or flammable liquids.
conditions (moisture, humidity, rain, infiltration of liquids, dust, sea air, etc). The manufacturer’s recommended operating temperature range is -10°C to +50°C. Do not open, dismantle or attempt to repair the USB-Modem yourself. Do not drop, throw or bend the USB-Modem. Do not paint it. WEEE Approval The USB-Modem is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive).
Radio Waves Proof of compliance with international standards (ICNIRP) or with European Directive 1999/5/EC (R&TTE) is required of all modem models before they can be put on the market. The protection of the health and safety for the user and any other person is an essential requirement of these standards or this directive. THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO WAVES. The USB-Modem is a radio transmitter and receiver.
Maximum SAR for this model and conditions under which it was recorded. Body-worn SAR WCDMA2100 0.856 During use, the actual SAR values for this device are usually well below the values stated above. This is because, for purposes of system efficiency and to minimize interference on the network, the operating power of your mobile device is automatically decreased when full power is not needed for the call. The lower the power output of the device, the lower its SAR value.
that if you are interested in further reducing your exposure then you can easily do so by limiting your usage or keep the device away from the head and body. Additional information about electromagnetic fields and public health are available on the following site: http://www.who.int/peh-emf The USB-Modem is equipped with a built-in antenna. For optimal operation, you should avoid touching it or degrading it.
