User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 95 10-Dec-12
11.46 Panasonic KX-UT136
11.46.1 Limitations Specific to Panasonic KX-UT136 Phone
There are no additional limitations except for those mentioned in Limitations and Differences.
11.46.2 Features Codes on Panasonic KX-UT136 Phone
This section presents the feature codes for PBX Services accessible during a call specific to the
Panasonic KX-UT136 Phone and serves as a supplement to
Quadro Feature Codes on IP Phone . s
PBX Services accessible during a call Keys/Soft Keys
Call Hold HOLD
Call Waiting DN button with a flashing LED
Call Blind Transfer Blind softkey ->dial the number -> #
Call Transfer with Consultation
TRANSFER -> dial the number -> call establishment
-> OK softkey
Call Conference
CONFERENCE->
dial the number
->
call
establishment -> CONFERENCE
To Put a Call on Hold
During the call press the HOLD button to place the call on hold. To resume a call on hold press
the corresponding green flashing DN (Directory Number) button.
To Accept a Second Incoming Call
Call waiting tone (short beeps) indicates an incoming call. Press the flashing (green light) DN
(Directory Number) button to accept a second incoming call. First call will be disconnected
automatically.
To Blind Transfer a Call
During an active call press the Blind softkey, this puts the call in progress on hold. Then dial the
number to where you want to transfer the call and press # to transfer the call. You will be
disconnected automatically from both calls.
To Transfer a Call with Consultation
During a call press the TRANSFER button to make a call and automatically place the active call on
hold. Dial the number to where you want to transfer the call. Once the call is established, press
the OK softkey to transfer the call. You will be disconnected automatically from both calls.
To Set up a Conference Call
During a call press the CONFERENCE button to make a call which automatically places the active
call on hold. Dial the number, once the call is established, press the CONFERENCE button again
to begin the conference call.
To end the three-way conference call, go on-hook during a conference.