User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 92 10-Dec-12
11.43 Alcatel Temporis IP 800
11.43.1 Limitations Specific to Alcatel Temporis IP 800 Phone
There are no additional limitations except for those mentioned in Limitations and Differences.
11.43.2 Features Codes on Alcatel Temporis IP 800 Phone
This section presents the feature codes for PBX Services accessible during a call specific to the
Alcatel Temporis IP 800 Phone and serves as a supplement to
Quadro Feature Codes on IP
Phones.
PBX Services accessible during a call Keys/Soft Keys
Call Hold Hold
Call Waiting Answer
Call Blind Transfer Tran ->dial the number -> Tran
Call Transfer with Consultation
Tran -> dial the number -> call establishment ->
Tran
Call Conference
Conf-> dial the number-> call establishment ->
Conf
To Put a Call on Hold
During the call press the Hold softkey or the button to place the call on hold. Press the
Resume softkey or the
button again to return to the call.
To Accept a Second Incoming Call
Call waiting tone (short beeps) indicates an incoming call. During a call, press the Answer softkey
or the blinking (green light) LINE button to accept the second incoming call. First call is placed on
hold. To switch between the calls, use the Up or Down navigation keys and press Resume or
press the blinking (green light) LINE button.
To Blind Transfer a Call
During an active call press the Tran softkey or the button, this puts the call in progress on
hold. Then dial the number to where you want to transfer the call and press the Tran softkey or
the
button or hang up. You will be disconnected automatically from both calls.
To Transfer a Call with Consultation
During a call press the Tran softkey or the button to make a call and automatically place
the active call on hold. Dial the number to where you want to transfer the call. Once the call is
established, press the Tran softkey or the
button again to transfer the call. You will be
disconnected automatically from both calls.
To Set up a Conference Call
During a call press the Conf softkey or the button to make a call which automatically places
the active call on hold. Dial the number, once the call is established, press the Conf softkey or the
button. To end the three-way conference call, hang up the phone.