User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 70 10-Dec-12
11.30 Linksys SPA942/941 IP Phones
11.30.1 Limitations Specific to Linksys SPA942/94
There are no additional limitations except for those mentioned in Limitations and Differences.
11.30.2 Features Codes on Linksys SPA942/941
This section presents the feature codes for PBX Services accessible during a call specific to the
Linksys SPA942 Phone and serves as a supplement to
Quadro Feature Codes on IP Phones.
PBX Services accessible during a call Keys/Soft Keys
Call Hold
hold 1
st
Line
Call Blind Transfer
right navigation button

“bxfer”

dial the
number
Call Transfer with Consultation
“xfer”

dial the number

consult

“xfer”
Call Conference
“conf”

dial the number

“conf”
To Put a Call on Hold
Press the Hold button and press the 1
st
Line key to resume the call. If you have another
call, immediately press the 1
st
Line key to swap calls (sending the 1-st call on hold) or press
the Hold
button then press the 1
st
Line key to talk to the second caller.
If you want to switch to the first call just press the 1
st
Line key again which will send the
second call on hold. While talking, go on hook to terminate the current call (or if you are talking
on the speakerphone, press the Speaker
button).
To Blind Transfer a Call
Press the right arrow on the navigation button once, then the bxfer button. Dial the
destination number and #.
Or go off hook then press the xfer button dial the destination number and # then press the xfer
button again.
To Transfer a Call with Consultation
Press the xfer button and dial the destination number and # talk to the caller then and press the
xfer button again.
To Set up a Conference Call
Press the conf button and dial the destination number and #, then press the conf button again. If
you want to exit, press the join button.