User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 65 10-Dec-12
11.26 Sipura SPA-841 IP Phone
11.26.1 Limitations Specific to SPA-841 IP Phone
There are no additional limitations except for those mentioned in Limitations and Differences.
11.26.2 Feature Codes on SPA-841 IP Phone
This section presents the feature codes for PBX Services accessible during a call specific to
SPA-841 IP Phone and serves as a supplement to
Quadro Feature Codes on IP Phones.
PBX Services accessible during a call
Keys / Soft Keys
Call Hold Hold
Call Waiting Line key with a blinking LED
Call Blind Transfer, Call Transfer with Consultation
“xfer
dial the number
dial”
xfer”
Call Conference
“conf”
dial the number
“dial”
“conf”
To Put a Call on Hold
During a call press the Hold key. The LED of the corresponding line key will flash red, indicating
that there is a call is on hold. To resume a call on hold, press the line key associated with the
held call.
While a call is on hold, you can make a new call: press the line key of a free line and dial a
number. If the phone is connected to two calls, use the associated line keys to switch between the
calls.
To Accept a Second Incoming Call
During a call, press the line key with a flickering LED to put a call in progress on hold and receive
an incoming call.
To Blind Transfer a Call
During a call, press the “xfer soft key, which is the soft key on the far right. This puts the call in
progress on hold and provides a dial tone.
Dial the number the call is to be transferred to and press the “dialsoft key.
Just as you hear ringing, press “xfer” again. The held call will be transferred to the called party.
To Transfer a Call with Consultation
During a call, press the “xfer soft key, which is on the far right. This puts the call in progress on
hold and provides a dial tone on a free line.
Dial the number the call is to be transferred to and press the dial” soft key.
After consulting the called party, press the “xfer” key again. The call on hold will be transferred to
the called destination.
To Set up a Conference Call
During a call, press the “conf” key, which is the soft key on the far left. This puts the call in
progress on hold and provides a dial tone. Dial a third participant's telephone number and press
the “dial” soft key. After the call is set up, press the “conf” key again to join the held and active
calls in a conference call.