User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 62 10-Dec-12
To Transfer a Call with Consultation
Press the “LINE” button to select an idle line to use for transfer; this will place the other
party on hold immediately. After pressing the soft key of corresponding free Line, press the
“LINE” button
several times until the active account will be selected. Dial the number that
you wish to transfer to and after confirmation from the party, press the “CALL TRANSFER”
button. The phone will display the following message: “Dial Number (Blind) OR Select Line
(Attended)”. Press the “LINE” button and select the line on hold.
Please Note: To transfer calls across SIP domains, SIP service providers must support transfer
across SIP domains. If users enter a wrong number and wish to cancel the transfer, just press the
“CALL TRANSFER” button again or the “Cancel” softkey to cancel the transfer or press the
“HOLD” key to hold the line and retry again.
To Set up a Conference Call
Place the first call on hold by pressing the “LINE” button to call the second party. After
pressing the soft key of corresponding free Line, press the “LINE” button
several times until
the active account will be selected. Once the user has established the second call, press the
“CONFERENCE” button
then select the line on hold by pressing the “Line” button
again and selecting the line by pressing the corresponding line softkey. This would bring the three
parties together in a 3 way conference.
If after pressing the “CONFERENCE” button
, a user decides not to conference anyone,
press the corresponding ”End” soft key to cancel the conference.
There are two ways to end a conference. The first way is to press “HOLD”. This breaks the
conference and places both parties on hold. The user can now speak to an individual party by
selecting the corresponding LINE. The second way to end a conference is to simply hang up and
terminate the call.