User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 55 10-Dec-12
11.20 Grandstream GXP2124 Phone
11.20.1 Limitations Specific to Grandstream GXP2124 Phone
There are no additional limitations except for those mentioned in Limitations and Differences.
11.20.2 Features Codes on Grandstream GXP2124 Phone
This section presents the feature codes for PBX Services accessible during a call specific to the
Grandstream GXP2000/GXP2124 Phone and serves as a supplement to
Quadro Feature Codes
on IP Phones.
PBX Services accessible during a call Keys/Soft Keys
Call Hold Hold
Call Waiting LINEx
Call Blind Transfer Transfer ->dial the number -> Transfer
Call Transfer with Consultation
LINEx -> Dial -> call establishment -> Transfer ->
LINEx (in hold line)
Call Conference
LINEx -> Dial -> call establishment -> CONF ->
LINEx (in hold line)
To Put a Call on Hold
During the call press the Hold softkey to place the call on hold. To resume the call press the
corresponding blinking LINE.
To Accept a Second Incoming Call
To answer the incoming second call press the corresponding blinking (red light) LINEx button, this
automatically places the active call on hold.
To Blind Transfer a Call
During an active call press the button or the Transfer softkey, this puts the call in progress
on hold. Then dial the number and press the
button or the Transfer softkey to complete
transfer of active call). You will be disconnected automatically from both calls.
To Transfer a Call with Consultation
During a call press the LINEx button (free line) to make a call and automatically place the active
line on hold. Dial the number, once the call is established, press the
button then the LINE
button of the waiting line to transfer the call. You will be disconnected automatically from both
calls.
To Set up a Conference Call
During a call press the LINEx (free line) button to make a call which automatically places the
active line on hold. Dial the number, once the call is established, press the
button then the
LINEx that is on hold (blinking) to join both calls into a conference.
To end a conference call:
During a conference call, press the End Call soft key.