User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 51 10-Dec-12
11.18 Grandstream BT100/200
11.18.1 Limitations Specific to Grandstream BT100/200
There is a licensing limitation for G.729 codec on the GrandStream phones (only 2 G.729 codec
channels are supported). It is impossible to initiate conference on the phone when all participants
are using the G.729 codec. See also
Limitations and Differences.
11.18.2 Feature Codes on Grandstream BT100/200
This section presents the feature codes for PBX Services accessible during a call specific to
Grandstream BT100/200 and serves as a supplement to
Quadro Feature Codes on IP Phones.
To Put a Call on Hold
During the call press the HOLD button to place the call on hold.
To resume the call press the HOLD button again to realize the previously held call.
Please Note: If, after holding the call, the party puts the phone on the idle mode (hangs up the
handset or presses the SPEAKER button) the “CALL ON HOLD” will be shown on the display to
notify the caller about call in hold. And if picking up the handset or pressing the SPEAKER button,
the call in hold will be automatically reconnected.
You can put a call on hold and switch directly to another line by pressing the FLASH key or HOOK
switch during a call.
When juggling between calls, you do not have to press the hold button to go from one call to the
next. The phone automatically puts your current call on hold as soon as you press the FLASH key
or HOOK switch. This provides a dial tone enabling you to make a second call.
2
HOOK switch is the button on the phone, which is always pressed when the handset is on-hook and always
realized when the handset is off-hook.
PBX Services accessible during a
call
Keys/Soft Keys
Call Hold HOLD
Call Waiting FLASH or HOOK
2
Call Blind Transfer
TRANSFER ->
dial the number
-> SEND
or #
Call Transfer with Consultation
FLASH
or HOOK
->
dial the number
->
SEND or # -> call establishment ->
TRANSFER -> FLASH or HOOK
Call Conference
CONFERENCE -> dial the number ->
SEND or # -> call establishment ->
CONFERENCE