User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 50 10-Dec-12
11.17 IpDialog SipTone II
11.17.1 Limitations Specific to IpDialog SipTone II
There are no additional limitations except for those mentioned in Limitations and Differences.
11.17.2 Feature Codes on IpDialog SipTone II
This section presents the feature codes for PBX Services accessible during a call specific to
IpDialog SipTone II and serves as a supplement to
Quadro Feature Codes on IP Phones.
PBX Services accessible during a call
Keys/Soft Keys
Call Hold DND/HOLD or Line1/2
Call Waiting Line1/2
Call Blind Transfer VM/XFER
Call Transfer with Consultation VM/XFER
Call Conference SET/CONF
To Put a Call on Hold
There are two options of putting a call on hold:
1. Press DND/HOLD to put the call in progress on hold. To resume a call on hold, press
DND/HOLD again. To make a new call while another is on hold, press Line1/2.
2. Press Line1/2 to put the call in progress on hold and switch directly to line 2. To terminate
the call in progress and resume the held one, press MENU/HANGUP. To resume the call
on hold without terminating the call in progress, press Line1/2.
To Accept a Second Incoming Call
Press Line1/2 to put the call in progress on hold and accept an incoming call. To switch between
the calls, use Line1/2. To terminate the active call and resume the held one, press
MENU/HANGUP.
To Blind Transfer a Call
During a call, press VM/XFER to put the call in progress on hold and a receive dial tone.
Dial a phone number that the call on hold is to be transferred to and press OK. As soon as the
held party is transferred to the specified destination, you will be disconnected from the held call.
To Transfer a Call with Consultation
During a call, press Line1/2 to switch to line 2 and make a call. The call in progress is put on
hold. Consult the called party.
Press VM/XFER. The person on hold is transferred to the called party disconnecting you from
both calls.
To Set up a Conference Call
During a call, switch to line 2 by pressing Line1/2 and make or accept an incoming call.
Press SET/CONF to join both parties in a conference call.