User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 29 10-Dec-12
11.5 snom m9
11.5.1 Limitations Specific to snom m9
There are no additional limitations except for those mentioned in Limitations and Differences.
11.5.2 Features Codes on snom m9
This section presents the feature codes for PBX Services accessible during a call specific to
snom m9 and serves as a supplement to
Quadro Feature Codes on IP Phones.
PBX Services accessible during a call
Keys/Soft Keys
Call Hold
Options softkey

Hold Call
Call Waiting
Options softkey

Accept Call
Call Blind Transfer
Options softkeyTransfer Calldial
the number

OK
Call Transfer with Consultation
Options
softkey
New Call
dial the
number

call establishment

Options
Bridge CallsOK
Call Conference
Options softkeyNew Calldial the
number

call establishment

Options
ConferenceOK
To Put a Call on Hold
During an active call, press the Options softkey, scroll to Hold Call and press the OK softkey to
place the call on hold. To resume the held call, press the Resume softkey.
To Accept a Second Incoming Call
When the line is busy, the user hears a call waiting tone notifying the user that a call is waiting
and will see a notification about incoming call on the phones display. Press the Options softkey,
scroll to Accept Call and press the OK softkey to answer the second incoming call. This
automatically places the active call on hold. Press the Options softkey again, scroll to Toggle
Calls and press the OK softkey to toggle between the calls.
To Blind Transfer a Call
During an active call press the Options softkey, scroll to Transfer Call and press the OK softkey.
This puts the call in progress on hold. Dial the number to where you want to transfer the call and
press the OK button. You will be disconnected automatically from both calls.
To Transfer a Call with Consultation
During an active call press the Options softkey, scroll to New Call and press the OK softkey. This
puts the call in progress on hold. Dial the number to where you want to transfer the call. Once the
call is established, press the Options softkey, scroll to Bridge Calls and press the OK softkey to
transfer the call. You will be disconnected automatically from both calls.
To Set up a Conference Call
During an active call press the Options softkey, scroll to New Call and press the OK softkey,
which automatically places the active call on hold. Dial the number, once the call is established,
press the Options softkey, scroll to Conference and press the OK softkey to begin the
conference call.
To end the three-way conference call, hang up the phone.