User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 27 10-Dec-12
11.3 snom 220
11.3.1 Limitations Specific to snom 220
There are no additional limitations except for those mentioned in Limitations and Differences.
11.3.2 Features Codes on snom 220
This section presents the feature codes for PBX Services accessible during a call specific to
snom 220 and serves as a supplement to
Quadro Feature Codes on IP Phones.
PBX Services accessible during a call
Keys/Soft Keys
Call Hold Hold or F1
Call Waiting Key with a blinking LED
Call Blind Transfer,
Call Transfer with Consultation
F2
Call Conference F3
To Put a Call on Hold
During a call, press the Hold key. This puts the call in progress on hold and provides a dial tone
on a free line. To make a call new while another is on hold, dial your desired phone number. To
resume a call on hold, press either the Hold key again or the line key associated with the held
call.
You can also put a call on hold and immediately receive a dial tone by pressing any free line key.
To Accept a Second Incoming Call
Press the key with a blinking LED. This puts a call in progress on hold and receives an incoming
call.
To terminate the call in progress and resume the one on hold, press Cancel. To put the call in
progress on hold and resume the one on hold, press the key with a blinking LED.
You may also reject an incoming call by pressing F4 or Cancel.
To Blind Transfer a Call
During a call, press the key F2 to put the call party on hold and receive a dial tone.
Dial the phone number that the call is to be transferred to and press OK. The person on hold will
be transferred to the specified destination.
To Transfer a Call With Consultation
Press the Hold key to hold the call and receive a dial tone.
Dial the phone number that the call is to be transferred to. Consult the called party.
Press the function key F2 to connect the person on hold to the called party.
To Set up a Conference Call
When the phone is connected with two calls, one on hold and one active, press the function key
F3 or the Conf key to connect the parties for a conference call.