User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 26 10-Dec-12
11.2 snom 200
11.2.1 Limitations Specific to snom 200
There are no additional limitations except for those mentioned in Limitations and Differences.
11.2.2 Features Codes on snom 200
This section presents the feature codes for PBX Services accessible during a call specific to
snom 200 and serves as a supplement to
Quadro Feature Codes on IP Phones.
PBX Services accessible during a call
Keys/Soft Keys
Call Hold
Call Waiting Line key with a blinking LED
Call Blind Transfer,
Call Transfer with Consultation
“Xfer”
Call Conference “Cnf.On”
To Put a Call on Hold
During a call, press the R/Hold key. This puts the call in progress on hold and provides a dial
tone on a free line. To make a new call while another is on hold, dial your desired phone number.
To resume a call on hold, press either the R/Hold key again or the line key associated with the
held call.
You can also put a call on hold and immediately receive a dial tone by pressing any free line key.
To Accept a Second Incoming Call
Press the key with a blinking LED. This puts a call in progress on hold and receives an incoming
call.
To terminate the call in progress and resume the one on hold, press Cancel.
To Blind Transfer a Call
During a call, press the soft key “Xfer”. This puts the call in progress on hold and provides a dial
tone.
Dial the phone number that the call is to be transferred to and press the key
. The person on
hold will be transferred to the specified destination.
To Transfer a Call with Consultation
During a call, press the hold key . This puts the call in progress on hold and provides a dial
tone.
Dial the phone number that the call is to be transferred to and press the key
. Consult the
second party.
Press the soft key “Xfer” or hook on the handset to connect the person on hold to the called
party.
To Set up a Conference Call
When the phone is connected with two calls, one on hold and one active, press the function key
“Cnf.On” to connect all three parties for a conference call. Pressing the function key “Cnf.Off”
during a conference call disconnects it and drops the calls.